Update








Lots going on. Sourcing boat parts from all over the world. 
Found some cool old stock as well as modern mechanical goodies. Antique rocket theme cleats, Vollrath 1 1957 steering wheel, hydraulic steering system, custom made 6061 aluminum 1/4" plate motor well reinforcement system, hydraulic jack plate, stainless thru-hull fittings, stainless folding foot steps, aluminum folding foot boards, aluminum folding transom platform, stainless door hinges, stainless window/hatch sliding/adjustable supports, large bimini top, white rub rail, new old stock aluminum cabin door opening screened window, 5000 BTU a/c unit, stainless hinges, 36 gallon fuel tank (will be under rear bench seat), marine upholstery foam, Advantech floor board materials, vinyl 1/4" thick tongue/groove interior panels, 1/8" vinyl pebble board exterior side trim panel materials, lots of epoxy, etc....

Comments

Post a Comment

Popular posts from this blog

Tale of The Forlorn Yacht

Image
Not so long ago, in a town far, far away in upstate New York some may say. Away in a dark, dank domicile a forlorn little yacht lay. Long forgotten by her maker, she laid in wait for someone to take her. This journey starts with a simple ad in the local Craigslist that stated  "Get Me Out Of Here! Any offers considered." Or something to that effect. Thus starting a process we may all regret. Spying this site from many states away in search of antique boats for which to play. Mr. E reached out to heed the call. Emails would come, emails would go, for weeks it seemed, with nary a call. Then one fateful night Gordon did call but it was not as easy as this at all. Not convinced his heart was true, more pleading he must do. Then came a call from Marguerite it seemed Mr. E might have the boat of his dreams. Plans were laid, negotiations were made, and soon a deal was struck. Reaching into his coffers he made her an offer of $500 bucks. Fearing the boat would soon be m
Read more

Bits and Pieces

Image
  Just getting things ready to hook up. New 9 foot switch and throttle cables fitted.  New harness and everything is being routed to the engine.   Fridge is installed. Next to it will be the hot water heater. Behind the hot water heater will be a 10 gallon fresh water tank with 12 volt water pump that will supply a faucet. The butane stove will be stored under the counter top in the area above the fridge when not in use.
Read more

Holy Slat

Image
Door building in progress. Many thanks to William for letting me borrow this handy drill guide tool. It would not be possible without it! Lots of holes, lots of epoxy, lots of pegs, lots of measuring, lots of fitting, lots of work... This is the head door in progress. The cabin door is next but it is an open frame of 4SF (4 sides finished) of 2x6 and 2x4's that will house a small new old stock vintage aluminum single hung screened window and a drop panel in the bottom for the 5000 BTU window air conditioner unit. Shown here we are in the process of making it out of oak 4SF 2x6, 2x2, 1x16 and 1x12's and pegging it together. After it is epoxied it was clamped and held together for a couple days until dry. It is now very solid. The head door is a split design that will be held together in the middle with stainless spring loaded self closing hinges to make it operate as a solid door. When the door is opened it will swing into the hallway but would be too wi
Read more